• Home
  • Shop
  • About Us
  • Contact Us
  • Application Advice
  • Affiliates and Partners
Cart: 0 item (s) - £0.00

Advanced Invisi Film Kit With Fork & Crank Guards

Advanced Invisi Film Kit With Fork & Crank Guards
Advanced Invisi Film Kit With Fork & Crank Guards
Advanced Invisi Film Kit With Fork & Crank Guards
Advanced Invisi Film Kit With Fork & Crank Guards
Advanced Invisi Film Kit With Fork & Crank Guards
Product Condition: New
£68.00
You Will Earn 68 points which is the equivalent of £0.68
Advanced InvisiFilm Full Suspension & Curved Protection/Helitape kit
We've literally crammed as much as we can onto this sheet! 

Most of the strips are notched to allow easy fitting to curvature as the film is very thick so helps you fit it easily and correctly!  

​All shapes in image supplied sizes in MM as follows:
x2 seat stay strips 300x70mm
x2 chainstay strips 300x60mm
x1 down or top tube strip 400x86 tapered
x2 downtube sides 558x38mm
x1 downtube strip solid 555x30mm
x1 seatube backside 200x70mm
x1 downtube tapered 180x80mm
x2 gusset/tube strips 170x25mm
x1 headtube strip with badge notch 125x30mm
Various Gusset fins & cable rub stoppers.
And set of notched fork guards & crank covers

 40micron/2.4mm thick Clear Protective KPMF abrasion stop/stoneguard vinyl.
Heat and plenty of water is advised when fitting Clear Protection Invsi Films 




Always ensure you have cleaned your frame with isopropyl alcohol (can be purchased from ebay or hardware or medical suppliers.) Even brand new frames have dirt and dust on them. Trim a small square of the application tape provided to lift off the peice your working on, and it will help you not touch the actual invisifilm during the application. 
Spray the adhesive side of the piece your working on with water don't be stingy get it wet! 
Proceed to lining up into position, and start wiping with the application tool suppled from the center outwards. Pushing the water out, and warming the area with a heat gun/hairdryer at the same time. Start with a small piece to get used to the technique. If you really wet the invisifilm you will need to check back within an hour of application with a heat source to ensure you have dried the edges and got those stuck down. If you went for the dry application with heat you wont need to worry about this. 
Related Products